Home › Engine / Hybrid System › 2AR-FE STARTING › ENGINE SWITCH
RM19V0EQ _51 Engine / Hybrid System _014580 2AR-FE STARTING _0073967 ENGINE SWITCH G

2AR-FE STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

A256118
5.396,1.219 5.625,1.219 false 5.302,0.865 5.438,0.375 5.438,0.375 5.5,0.375 false 4.417,0.865 4.188,0.271 4.188,0.271 4.094,0.271 false 3.802,0.198 4.115,0.479 0.313,0.281 10 SS1 5.563,0.292 5.875,0.583 0.313,0.292 10 SS2 5.688,1.135 6.021,1.406 0.333,0.271 10 GND

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SS1) - 6 (GND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (GND)
5 (SS1) - 6 (GND) Pushed Below 1 Ω
1 (SS2) - 6 (GND)


If the result is not as specified, replace the engine switch.


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.

HINT:
·

If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the engine switch indicator light will not illuminate.

·

If the voltage is too low, the indicator light will not illuminate.



OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 9 (SWIL)
Battery negative (-) → Terminal 6 (GND)
Illuminates


A256118
1.833,0.781 1.375,0.469 1.375,0.469 1.24,0.469 false 4.646,1.313 4.198,1.49 4.198,1.49 4.083,1.49 false 5.375,1.229 5.625,1.229 false 1.052,0.385 1.25,0.688 0.198,0.302 10 false *a 3.719,1.417 4.083,1.75 0.365,0.333 10 false SWIL 5.677,1.156 6.021,1.49 0.344,0.333 10 false GND
*a Indicator Light - -


If the result is not as specified, replace the engine switch.