Home › Engine / Hybrid System › CRUISE CONTROL › CLUTCH SWITCH › 2011.10–2013.07
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0073972 CLUTCH SWITCH G

CRUISE CONTROL  CLUTCH SWITCH  INSPECTION  


PROCEDURE

Hide 88280A 1.INSPECT CLUTCH SWITCH ASSEMBLY

a.
E144328
1.135,1.042 1.406,1.719 false 1.135,2.74 1.406,2.052 false 0.073,0 2.604,0.365 2.531,0.365 10 false *a 2.448,2.51 2.656,2.677 0.208,0.167 10 false *b 2.865,2.51 3.052,2.677 0.188,0.167 10 false *c 0.833,0.927 1.146,1.125 0.313,0.198 10 false CL- 0.833,2.719 1.146,2.917 0.313,0.198 10 false CL+
*a Component without harness connected (Clutch Switch Assembly)
*b Pushed in
*c Free


Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Switch Condition Specified Condition
1 (CL+) - 2 (CL-) Switch pin pushed in Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Switch Condition Specified Condition
1 (CL+) - 2 (CL-) Switch pin free 10 kΩ or higher