Home › Drivetrain › CLUTCH › CLUTCH SYSTEM › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014583 CLUTCH _0073990 CLUTCH SYSTEM N

CLUTCH  CLUTCH SYSTEM  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


HINT:
·

If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed the air from the clutch hydraulic system.

·

In case of brake fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and bleeder before bleeding.



PROCEDURE

Hide 1.FILL BRAKE FLUID RESERVOIR

Hide 2.BLEED CLUTCH LINE

a.

Remove the release cylinder bleeder plug cap.


b.

Connect a vinyl tube to the release cylinder bleeder plug.


c.

Depress the clutch pedal 5 times, and then loosen the release cylinder bleeder plug while the pedal is depressed.


d.

When fluid no longer comes out, tighten the release cylinder bleeder plug, and then release the clutch pedal.


e.

Repeat both of the previous 2 steps 6 times.


f.

Tighten the release cylinder bleeder plug.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


g.

Depress the clutch pedal 10 times or more and confirm its operation.

NOTICE:

This must be performed before the engine is started.



h.

Install the release cylinder bleeder plug cap.


i.

Check that all the air has been bled from the clutch line.


Hide 3.INSPECT BRAKE FLUID LEVEL IN RESERVOIR