Home › Drivetrain › CLUTCH › CLUTCH PEDAL › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014583 CLUTCH _0073991 CLUTCH PEDAL A

CLUTCH  CLUTCH PEDAL  REMOVAL  


PROCEDURE

Hide 83100 1.REMOVE COMBINATION METER ASSEMBLY

Hide 2.DISCONNECT CONNECTOR (w/ Cruise Control System)

a.

Disconnect the clutch switch assembly connector.


Hide 31453A 3.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS PIN

a.
C135429

Remove the clip and clutch master cylinder push rod clevis pin.


Hide 4.REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY

a.
C248213

Remove the bolt, 2 nuts and clutch pedal support sub-assembly.


Hide 88280A 5.REMOVE CLUTCH SWITCH ASSEMBLY (w/ Cruise Control System)

a.
C248573

Remove the nut and clutch switch assembly from the clutch pedal support sub-assembly.


Hide 6.REMOVE CLUTCH PEDAL STOPPER BOLT (w/o Cruise Control System)

a.
C248572

Remove the clutch pedal stopper bolt from the clutch pedal support sub-assembly.


Hide 31394A 7.REMOVE TORSION SPRING

a.

While the clutch pedal is fully depressed, remove the torsion spring.


Hide 8.REMOVE CLUTCH PEDAL SUB-ASSEMBLY

a.
C248214

Remove the bolt and nut.

HINT:

When removing the nut, keep the bolt from rotating.



b.

Remove the clutch pedal sub-assembly from the clutch pedal support sub-assembly.


Hide 31353 9.REMOVE CLUTCH PEDAL SPRING HOLDER

a.

Remove the clutch pedal spring holder from the clutch pedal support sub-assembly.


Hide 31321 10.REMOVE CLUTCH PEDAL PAD

a.

Remove the clutch pedal pad from the clutch pedal sub-assembly.


Hide 31301C 11.REMOVE CLUTCH PEDAL BUSHING

a.
C204647

Remove the 2 clutch pedal bushings and clutch pedal shaft collar from the clutch pedal sub-assembly.


Hide 31301B 12.REMOVE NO. 1 CLUTCH PEDAL CUSHION

a.
C204644

Using needle-nose pliers, remove the 2 No. 1 clutch pedal cushions from the clutch pedal sub-assembly.


Hide 13.REMOVE CLUTCH PEDAL TURNOVER BUSHING

a.
C204645

Remove the clutch pedal turnover bushing from the clutch pedal sub-assembly.


Hide 31453B 14.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSHING

a.
C204646

Using an (8 mm) hexagon wrench and a hammer, remove the clutch master cylinder push rod clevis bushing from the clutch pedal sub-assembly.