Home › Drivetrain › CLUTCH › CLUTCH UNIT › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014583 CLUTCH _0073994 CLUTCH UNIT G

CLUTCH  CLUTCH UNIT  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

C250788

a.

Using a vernier caliper, measure the rivet head depth.

Minimum rivet depth:

0.3 mm (0.0118 in.)


If necessary, replace the clutch disc assembly.


b.

Install the clutch disc assembly onto the manual transaxle assembly.

HINT:

Insert the clutch disc assembly in the correct direction.



c.
C187770

Using a dial gauge, measure the clutch disc assembly runout.

Maximum runout:

0.8 mm (0.0314 in.)


If necessary, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

C287094
0.49,0.583 0.729,0.823 0.24,0.24 10 false A 1.188,0.365 1.469,0.635 0.281,0.271 10 false B

a.

Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

Maximum:

A (Depth): 0.5 mm (0.0196 in.)

B (Width): 6.0 mm (0.236 in.)


If necessary, replace the clutch cover assembly.


Hide 13405 3.INSPECT FLYWHEEL SUB-ASSEMBLY

C204660

a.

Using a dial indicator, check the flywheel sub-assembly runout.

Maximum runout:

0.1 mm (0.00393 in.)


If necessary, replace the flywheel sub-assembly.