Home › Drivetrain › EB62 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE UNIT › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014584 EB62 MANUAL TRANSMISSION / TRANSAXLE _0074002 MANUAL TRANSAXLE UNIT G

EB62 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE UNIT  INSPECTION  


PROCEDURE

Hide 33402 1.INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY

a.
C200255

Using a caliper gauge, measure the inside diameter of the reverse idler gear sub-assembly.

Standard inside diameter:

20.056 to 20.074 mm (0.7896 to 0.7903 in.)


Maximum inside diameter:

20.074 mm (0.7903 in.)


If the inside diameter is more than the maximum, replace the reverse idler gear sub-assembly.


b.

Using a micrometer, measure the outer diameter of the reverse idler gear shaft sub-assembly.

Standard outer diameter:

19.984 to 20.000 mm (0.7868 to 0.7874 in.)


Minimum outer diameter:

19.984 mm (0.7868 in.)


If the outer diameter is less than the minimum, replace the reverse idler gear shaft sub-assembly.