1.INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH
Using a dial indicator, measure the front differential side gear backlash.
0.05 to 0.20 mm (0.00197 to 0.00787 in.)
If the backlash is not as specified, replace the front No. 1 differential side gear thrust washers with washers of a different thickness. Use the table below to select a front No. 1 differential side gear thrust washer which will ensure that the backlash is within the specification.
| Mark | Specified Condition |
|---|---|
| 1 | 1.00 mm (0.0394 in.) |
| 2 | 1.10 mm (0.0433 in.) |
| 3 | 1.20 mm (0.0472 in.) |
| 4 | 1.30 mm (0.0511 in.) |
Select washers of the same thickness for both right and left sides.
41351F
2.INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER
Using a micrometer, measure the thickness of the front differential pinion thrust washer.
0.9 mm (0.0354 in.)
If the thickness is less than the minimum, replace the front differential pinion thrust washer.
41342F
3.INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.
17.975 mm (0.708 in.)
If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.