Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014585 DRIVE SHAFT / PROPELLER SHAFT _0074008 FRONT DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C091598

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C240884C01
0.115,1.656 0.969,1.917 0.854,0.26 12 false *B 0.115,0.052 0.74,0.375 0.625,0.323 12 false *A 1.427,1.385 1.698,1.635 0.271,0.25 10 false (A) 1.417,2.938 1.688,3.198 0.271,0.26 10 false (A)
*A LH Side
*B RH Side


Check whether the drive shaft dimensions (A) are within the following specifications.

NOTICE:

Keep the drive shaft assembly level during inspection.


Dimension (A):
for Automatic Transaxle for Manual Transaxle
LH Side 586.3 mm (1.92 ft.) 598.3 mm (1.96 ft.)
RH Side 905.1 mm (2.97 ft.) 897.1 mm (2.94 ft.)