Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT
RM19V0EQ _53 Suspension _014588 FRONT SUSPENSION _0074021 FRONT LOWER BALL JOINT A

FRONT SUSPENSION  FRONT LOWER BALL JOINT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43340A 1.INSTALL FRONT LOWER BALL JOINT ASSEMBLY

a.

Secure the front axle assembly in a vise using aluminum plates.

NOTICE:

When using a vise, do not overtighten it.



b.

Install the front lower ball joint assembly to the front axle assembly with a new nut.

Torque:
123 N*m (1254 kgf*cm, 91 ft.*lbf)

NOTICE:

Prevent oil from adhering to the threaded and tapered parts.



c.

Install a new cotter pin.

NOTICE:

Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



Hide 2.INSTALL FRONT AXLE ASSEMBLY