Home › Suspension › REAR SUSPENSION › REAR LOWER ARM
RM19V0EQ _53 Suspension _014589 REAR SUSPENSION _0074027 REAR LOWER ARM A

REAR SUSPENSION  REAR LOWER ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

The rear No. 2 suspension arm assembly RH can be installed directly to the vehicle.


PROCEDURE

Hide 48720A 1.INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

a.
C219642C02
3.302,0.406 3.313,0.417 false
V100136

Front of the Vehicle
V100143

Paint Mark


Temporarily tighten the rear No. 1 suspension arm assembly LH (inner side) with the bolt.

HINT:

Ensure that the paint mark faces the rear of the vehicle.



b.
C132503N08
2.646,0.792 3.031,1.063 0.385,0.271 10 false 4.0°

Set the rear No.1 suspension arm assembly in the position shown in the illustration, and fully tighten the bolt.

Torque:
100 N*m (1020 kgf*cm, 74 ft.*lbf)


Hide 48710A 2.INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 48740F 3.TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

a.
C241263C06
1.104,0.292 1.104,0.281 false
V100143

Paint Mark


Temporarily tighten the rear No. 2 suspension arm assembly LH (inside) with the bolt.

HINT:

Ensure that the paint mark faces the rear of the vehicle.



Hide 51206A 4.INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

Hide 48730F 5.TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH

a.
C276185C03
3.281,0.052 3.271,0.073 false
V100143

Paint Mark


Temporarily tighten the rear No. 2 suspension arm assembly RH (inside) with the bolt.

HINT:

Ensure that the paint mark faces the rear of the vehicle.



Hide 48730F 6.CONNECT REAR NO. 2 SUSPENSION ARM ASSEMBLY RH

a.

Connect the rear No. 2 suspension arm assembly RH (outer side) to the rear axle carrier sub-assembly with the bolt and nut.

NOTICE:

When temporarily tightening the bolt, keep the nut from rotating.


HINT:

Insert the bolt from the rear of the vehicle.



Hide 48730F 8.FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY RH

a.
C240569N06
0.208,1.229 0.458,1.448 0.25,0.219 10 true (A) 2.688,1.927 2.969,2.135 0.281,0.208 10 true (B)

Fully tighten the bolt (A).

Torque:
100 N*m (1020 kgf*cm, 74 ft.*lbf)


b.

Fully tighten the bolt (B).

Torque:
100 N*m (1020 kgf*cm, 74 ft.*lbf)

NOTICE:

When fully tightening the bolt, keep the nut from rotating.



Hide 9.INSTALL REAR WHEELS

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)

Hide 10.INSPECT AND ADJUST REAR WHEEL ALIGNMENT