Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
48780A
1.TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY
Temporarily tighten the rear strut rod assembly (rear side) with the bolt and nut.
When temporarily tightening the bolt, keep the nut from rotating.
Insert the bolt from the inside of the vehicle.
Support the rear axle carrier sub-assembly with a jack and a wooden block.
Connect the rear strut rod assembly (front side) with the bolt and nut.
When temporarily tightening the bolt, keep the nut from rotating.
2. STABILIZE SUSPENSION
48780A
3.FULLY TIGHTEN REAR STRUT ROD ASSEMBLY
Fully tighten the bolt (rear side).
When fully tightening the bolt, keep the nut from rotating.
Fully tighten the bolt (front side).
When fully tightening the bolt, keep the nut from rotating.
46430
4.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Connect the No. 3 parking brake cable assembly with the bolt.
5.INSTALL REAR WHEEL