Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
46430
2.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the bolt and separate the No. 3 parking brake cable assembly from the vehicle.
48780A
3.REMOVE REAR STRUT ROD ASSEMBLY
| *1 | Jack |
| *2 | Wooden Block |
Support the rear axle carrier sub-assembly with a jack using a wooden block.
Remove the bolt and nut, and separate the rear strut rod assembly (front side).
When removing the bolt, keep the nut from rotating.
Remove the bolt, nut and rear strut rod assembly from the rear axle carrier sub-assembly.
When removing the bolt, keep the nut from rotating.