Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM19V0EQ _54 Brake _014591 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074036 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.


PROCEDURE

Hide 84306 1.INSPECT SPIRAL CABLE SUB-ASSEMBLY

Hide 89245B 2.INSTALL STEERING SENSOR

a.
C238436C03
2.188,0.594 1.917,0.281 false 2.292,0.75 1.969,0.625 1.969,0.625 2.323,1.135 true 3.135,0.635 2.906,0.896 true 0.292,0.563 0.49,0.979 true 1.75,0.198 1.906,0.344 0.156,0.146 10 false *1 1.802,0.51 1.958,0.656 0.156,0.146 10 false *a 3.135,0.521 3.292,0.667 0.156,0.146 10 false *b 0.146,0.438 0.302,0.583 0.156,0.146 10 false *b
*1 Lock Pin
*a Guide
*b Pin


Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.

NOTICE:
·

Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

·

Do not damage the pins of the spiral cable sub-assembly and guides of the steering sensor.

·

The spiral cable sub-assembly can be rotate up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.




b.
C238437

Remove the lock pin from the steering sensor.


Hide 3. ALIGN FRONT WHEELS TO FACE STRAIGHT AHEAD

Hide 84307 4.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY