Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
47201
1.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
44763A
2.SEPARATE NO. 1 HOSE TO HOSE TUBE
Slide the clip and disconnect the No. 1 hose to hose tube from the brake booster assembly.
Remove the 2 nuts to separate the No. 1 hose to hose tube from the vehicle body.
47264A
3.REMOVE PUSH ROD PIN
44610
4.REMOVE BRAKE BOOSTER ASSEMBLY
Remove the 4 nuts and brake booster assembly from the vehicle body.
Do not kink or damage the brake lines.
44785
5.REMOVE BRAKE BOOSTER GASKET
Remove the brake booster gasket from the brake booster assembly.
47264D
6.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
Loosen the lock nut and remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.
44730
7.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY
Remove the brake vacuum check valve assembly from the brake booster assembly.
44696
8.REMOVE CHECK VALVE GROMMET
Remove the check valve grommet from the brake booster assembly.