Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for RHD)
RM19V0EQ _54 Brake _014592 BRAKE SYSTEM (OTHER) _0074047 BRAKE BOOSTER(for RHD) G

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for RHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 44610 1.INSPECT BRAKE BOOSTER ASSEMBLY

a.

Airtightness check

i.
C132722
2.438,0.146 2.896,0.552 0.458,0.406 10 *b 0.635,1.719 1.51,2.063 0.875,0.344 10 *c 0.885,1.625 1.51,1.917 0.625,0.292 10 *d 1.104,1.5 1.604,1.74 0.5,0.24 10 *e 0.802,0.146 1.385,0.458 0.583,0.313 10 *a
*a Correct
*b Incorrect
*c 1st
*d 2nd
*e 3rd


Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times.

If the pedal can be depressed nearly to the floor the first time, but on the 2nd and 3rd times cannot be depressed as far, the brake booster assembly is airtight.


ii.

Depress the brake pedal while the engine is running, and stop the engine with the brake pedal depressed.

If there is no change in the pedal reserve distance while holding the pedal depressed for 30 seconds, the brake booster assembly is airtight.



b.

Operation check

i.
C128542

Depress the brake pedal several times with the ignition switch off and check that there is no change in the pedal reserve distance when the pedal is depressed.


ii.
C128543

Depress and hold the brake pedal, then start the engine.

If the pedal goes down slightly, operation is normal.