If the left and right hoses are disconnected at the same time, be sure to place a mark on each hose to indicate its installation position.
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
47313A
3.REMOVE FRONT FLEXIBLE HOSE
for PBR Made:
Remove the union bolt and 2 gaskets, and separate the front flexible hose from the front disc brake cylinder assembly.
for ADVICS Made:
Remove the union bolt and gasket, and separate the front flexible hose from the front disc brake cylinder assembly.
| *1 | Clip |
Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.
Do not bend or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.
Remove the clip.
Remove the bolt and front flexible hose from the front shock absorber assembly.