Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE › 2011.10–2015.04
RM19V0EQ _54 Brake _014594 BRAKE (REAR) _0074051 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

·

If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.



HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 47319F 1.INSTALL REAR FLEXIBLE HOSE

a.

for PBR Made:

i.
C246335C01
0.644,1.07 0.801,1.219 0.157,0.15 10 *a 2.01,1.153 0.826,1.153 false
*a Lock Hole


Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and 2 new gaskets.

Torque:
30 N*m (305 kgf*cm, 22 ft.*lbf)

NOTICE:

Install the flexible hose lock securely into the lock hole in the disc brake cylinder.




b.

for ADVICS Made:

i.
C243121C02
1.885,0.979 2.458,1.542 2.458,1.542 2.656,1.542 true 2.688,1.458 2.865,1.615 0.177,0.156 10 *a
*a Lock Hole


Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

Torque:
33 N*m (340 kgf*cm, 25 ft.*lbf)

NOTICE:

Install the flexible hose lock securely into the lock hole in the disc brake cylinder.




c.

Install the rear flexible hose with the bolt.

Torque:
19 N*m (192 kgf*cm, 14 ft.*lbf)


d.

Install a new clip.

NOTICE:

Install the clip as far as it will go.



e.

Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not bend or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

·

Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




Hide 3.INSTALL REAR WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)