1.INSPECT BRAKE DISC INSIDE DIAMETER
Using a brake drum gauge or an equivalent tool, measure the inside diameter of the disc.
| Standard inside diameter | Maximum inside diameter | |
|---|---|---|
| for PBR Made | 190 mm (7.48 in.) | 191 mm (7.51 in.) |
| for ADVICS Made | 170 mm (6.69 in.) | 171 mm (6.73 in.) |
If the inside diameter is more than the maximum, replace the disc.
2.INSPECT PARKING BRAKE SHOE LINING THICKNESS
for PBR Made:
Using a ruler, measure the thickness of the parking brake shoe lining.
3.8 mm (0.150 in.)
1.5 mm (0.0591 in.)
Using a ruler, measure the thickness variation within the 260° range as shown in the illustration.
0.5 mm (0.0197 in.) or less.
If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe.
Always replace both the right and left parking brake shoes together.
for ADVICS Made:
Using a ruler, measure the thickness of the parking brake shoe lining.
2.0 mm (0.0787 in.)
1.0 mm (0.0394 in.)
If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe assembly.
Always replace both right and left parking brake shoes together.
3.INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT
for PBR Made:
Apply chalk to the inside surface of the disc, then slide the brake shoe against the disc to check the fit of the brake shoe lining to the disc.
If the contact between the disc and the parking brake shoe lining is improper, repair it using a brake shoe grinder or replace the parking brake shoe.
Wipe off the chalk after inspection.
for ADVICS Made:
Apply chalk to the inside surface of the disc, then slide the brake shoe against the disc to check the fit of the brake shoe lining to the disc. If the contact between the disc and the brake shoe lining is incorrect, repair it using a brake shoe grinder or replace the parking brake shoe assembly.
Always replace both right and left parking brake shoes together.
Wipe off the chalk after inspection.