If the power steering ECU assembly detects a malfunction, the EPS warning light comes on. At this time, the power steering ECU assembly stores a DTC in its memory.
If the power steering ECU assembly has been replaced, perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check the connection condition of the ECU wire sub-assembly and power steering ECU assembly connectors.
The ECU wire sub-assembly and power steering ECU assembly connectors are securely connected.
Check that the ground wire is securely installed with the bolt.
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>INSTALLATION
The ground wire is securely installed with the bolt.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check for DTCs.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
DTC is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| *a | Front view of wire harness connector
(to ECU Wire Sub-assembly) |
Disconnect the Ij2 connector from the ECU wire sub-assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| Ij2-5 (IG) - Body ground | Ignition switch ON | 9 to 16 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Power Steering ECU Assembly) |
Connect the Ij2 connector to the ECU wire sub-assembly.
Disconnect the power steering ECU assembly j1 and j2 connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| j1-1 (IG) - Body ground | Ignition switch ON | 9 to 16 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| j2-2 (PGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the power steering ECU assembly connector.
Perform the Active Test of the combination meter assembly using the intelligent tester.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display |
|---|
| Indicat. EPS |
Check the combination meter assembly.
The EPS warning light turns on or off in accordance with the intelligent tester operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG