When a problem occurs in the power steering system, the power source relay circuit is shut off to stop the power assist.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition |
|---|---|---|---|---|---|
| C1552/22 | PIG Power Supply Voltage Malfunction | PIG power source circuit malfunction inside ECU | ·
EPS fuse ·
PIG power source circuit ·
ECU wire sub-assembly ·
Power steering ECU assembly |
EPS Warning Light: Comes on | Ignition switch ON again |
| C1554/23 | Power Supply Relay Failure | Power source relay circuit malfunction | ·
EPS fuse ·
PIG power source circuit ·
ECU wire sub-assembly ·
Power steering ECU assembly |
EPS Warning Light: Comes on | Ignition switch ON again |
If the power steering ECU assembly has been replaced, perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check the connection condition of the ECU wire sub-assembly and power steering ECU assembly connectors.
The ECU wire sub-assembly and power steering ECU assembly connectors are securely connected.
Check that the ground wire is securely installed with the bolt.
Click hereSteering>STEERING COLUMN>STEERING COLUMN ASSEMBLY>INSTALLATION
The ground wire is securely installed with the bolt.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Tune the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / EMPS / Data List.
Select the item "PIG Power Supply" in the Data List and read the value displayed on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| PIG Power Supply | Power source voltage to active motor | Min.: 0.0000 V
Max.: 20.1531 V |
Engine running and steering wheel being turned: 9 to 16 V | - |
| Tester Display |
|---|
| PIG Power Supply |
The normal condition value is displayed on the intelligent tester.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Front view of wire harness connector
(to ECU Wire Sub-assembly) |
Disconnect the Ij1 connector from the ECU wire sub-assembly.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Ij1-1 (PIG) - Body ground | Always | 9 to 16 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Power Steering ECU Assembly) |
Connect the Ij1 connector to the ECU wire sub-assembly.
Disconnect the power steering ECU assembly j2 connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| j2-1 (PIG) - Body ground | Always | 9 to 16 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| j2-2 (PGND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG