This is the power source circuit to operate the navigation ECU sub-assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the navigation ECU sub-assembly connectors.
Measure the resistance according to the value(s) in the table below .
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I64-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I64-4 (+B1) - I64-7 (GND1) | Always | 11 to 14 V |
| I64-3 (ACC1) - I64-7 (GND1) | Ignition switch ACC | 11 to 14 V |
| I67-1 (IG) - I64-7 (GND1) | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG