The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the navigation ECU sub-assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.
| *a | Front view of wire harness connector
(to Navigation ECU Sub-assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Disconnect the navigation ECU sub-assembly connector.
Disconnect the No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I67-25 (ADPG) - I146-9 (AUXO) | Always | Below 1 Ω |
| I67-26 (VAR+) - I146-6 (ARO) | Always | Below 1 Ω |
| I67-28 (VAL+) - I146-7 (ALO) | Always | Below 1 Ω |
| I67-27 (VA-) - I146-8 (ASGN) | Always | Below 1 Ω |
| I67-11 (AGND) - I146-10 (AGND) | Always | Below 1 Ω |
| I67-25 (ADPG) - Body ground | Always | 10 kΩ or higher |
| I67-26 (VAR+) - Body ground | Always | 10 kΩ or higher |
| I67-28 (VAL+) - Body ground | Always | 10 kΩ or higher |
| I67-27 (VA-) - Body ground | Always | 10 kΩ or higher |
| I67-11 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG