REAR TELEVISION CAMERA ASSEMBLY
Disconnect the T6 rear television camera assembly connector.
Measure the voltage on the wire harness side connector according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| T6-6 (CB+) - Body ground | B - Body ground | Power source | Within 60 seconds of turning the ignition switch ACC*1 | 5.5 to 7.05 V |
| Ignition switch ACC*2 | 5.5 to 7.05 V |
If the result is not as specified, there may be a malfunction on the wire harness side.
*1: for RHD before Oct. 2014, for LHD
*2: for RHD from Oct. 2014
Reconnect the T6 rear television camera assembly connector.
Measure the voltage and check for pulses at each terminal of the connector.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| T6-3 (CV+) - T6-2 (CV-) | W - R | Video signal | Ignition switch ON
Shift lever in R Camera lens not covered, displaying an image |
Pulse generation
(Refer to waveform 1) |
| Ignition switch ON
Shift lever in R Camera lens covered, blacking out the screen |
Pulse generation
(Refer to waveform 2) |
|||
| T6-5 (CGND) - Body ground | LG - Body ground | Shield ground | Always | Below 1 V |
A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.
If the result is not as specified, the rear television camera assembly may be malfunctioning.
| *a | Waveform 1 (camera lens is not covered, displaying an image) |
| *b | Waveform 2 (camera lens is covered, blacking out the screen) |
| *c | Synchronization Signal |
| *d | Video Waveform |
Reference (Oscilloscope waveform):
A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.
Waveform 1 (camera lens is not covered, displaying an image)
| Item | Content |
|---|---|
| Measurement terminal | T6-3 (CV+) - T6-2 (CV-) |
| Measurement setting | 200 mV/DIV., 50 μs./DIV. |
| Condition | Ignition switch ON, shift lever in R |
The video waveform changes according to the image sent by the rear television camera assembly.
The video waveform is constantly output when the ignition switch is turned to ACC.*
*: for RHD from Oct. 2014
Waveform 2 (camera lens is covered, blacking out the screen)
| Item | Content |
|---|---|
| Measurement terminal | T6-3 (CV+) - T6-2 (CV-) |
| Measurement setting | 200 mV/DIV., 50 μs./DIV. |
| Condition | Ignition switch ON, shift lever in R |
The video waveform changes according to the image sent by the rear television camera assembly.
The video waveform is constantly output when the ignition switch is turned to ACC.*
*: for RHD from Oct. 2014
RADIO AND DISPLAY RECEIVER ASSEMBLY