Home › Power Source / Network › 2AR-FE BATTERY / CHARGING › CHARGING SYSTEM
RM19V0EQ _57 Power Source / Network _014602 2AR-FE BATTERY / CHARGING _0074098 CHARGING SYSTEM J

2AR-FE BATTERY / CHARGING  CHARGING SYSTEM  Noise Occurs from Generator while Engine is Running  


INSPECTION PROCEDURE

PROCEDURE

1.CHECK LOOSENESS OF V-RIBBED BELT
a.

Check the tension of the belt by pushing it down with a finger.

OK:

The tension of the belt is enough.



Result:
Result
OK
NG



OK

2.CHECK V-RIBBED BELT FOR WEAR

NG

REPLACE V-RIBBED BELT TENSIONER ASSEMBLY

2.CHECK V-RIBBED BELT FOR WEAR
a.

Check the V-ribbed belt for wear.

OK:

The V-ribbed belt is not worn.



Result:
Result
OK
NG



OK

3.CHECK GENERATOR PULLEY WITH CLUTCH FOR WEAR

NG

3.CHECK GENERATOR PULLEY WITH CLUTCH FOR WEAR
a.

Check the generator pulley with clutch groove for wear or other defects.

OK:

The generator pulley with clutch groove is not damaged.



Result:
Result
OK
NG



OK

4.CHECK FOR NOISE WHILE GENERATOR PULLEY WITH CLUTCH IS OPERATING

NG

REPLACE GENERATOR PULLEY WITH CLUTCH

4.CHECK FOR NOISE WHILE GENERATOR PULLEY WITH CLUTCH IS OPERATING
a.

Perform a road test and check if noise occurs when decelerating.

OK:

Noise does not occur.



Result:
Result
OK
NG



OK

NG

REPLACE GENERATOR PULLEY WITH CLUTCH