1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
82662A
3.REMOVE NO. 1 RELAY BLOCK COVER
Disengage the 2 claws and remove the No. 1 relay block cover as shown in the illustration.
82720
4.REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY
Disengage the 2 claws as shown in the illustration.
| *1 | Protective Tape | - | - |
| *a | Pulled Position | - | - |
Using pliers, pull up the engine room junction block assembly at the position indicated in the illustration and disconnect the 4 connectors from the engine room relay block assembly.
When pulling the engine room junction block assembly, take care not to damage it.
Tape the pliers tip before use.
Disconnect the 2 connectors and remove the engine room junction block assembly.
Do not drop or allow any impact on parts.
Do not touch the connector.