CHECK DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start or Main Body / DTC.
Check the details of the DTC(s) (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
CLEAR DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start or Main Body / DTC / Clear.
Press the YES button.
Clear the DTC(s).