Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY(w/o Smart Entry and Start System) › 2011.10–2015.04
RM19V0EQ _58 Vehicle Interior _014605 DOOR LOCK _0074110 TRANSMITTER BATTERY(w/o Smart Entry and Start System) A

DOOR LOCK  TRANSMITTER BATTERY(w/o Smart Entry and Start System)  REPLACEMENT  


PROCEDURE

Hide 89751A 1.REMOVE TRANSMITTER HOUSING COVER

a.
B213771
1.563,1.427 2.156,1.313 false 2.208,1.24 2.458,1.438 0.25,0.198 10 false *1
*1 Protective Tape


Using a precision screwdriver with its tip wrapped in protective tape, pry open the transmitter housing cover.

NOTICE:

Do not forcibly pry the cover.


HINT:

Tape the screwdriver tip before use.



Hide 89071B 2.REMOVE DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY

a.
B213773
1.458,0.729 1.042,0.635 false 0.865,0.531 1.115,0.729 0.25,0.198 10 false *1
*1 Protective Tape


Using a precision screwdriver with its tip wrapped in protective tape, remove the door control transmitter module set sub-assembly from the transmitter housing case.

NOTICE:

Handle each part with care as they are delicate electrical parts.


HINT:

Tape the screwdriver tip before use.



Hide 89745A 3.REMOVE TRANSMITTER BATTERY

a.
B279946

Twist the coin in the direction of the arrow in the illustration, and remove the transmitter battery cover.


b.
B250771

Remove the transmitter battery (lithium battery: CR2016).

NOTICE:
·

Do not push the terminals with your finger.

·

Do not forcibly pry up the transmitter battery. The terminals may be damaged.

·

Do not touch the transmitter battery with wet hands. Water may cause rust.

·

Do not touch or move any components inside the transmitter. It may interfere with proper operation.

·

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.




Hide 89745A 4.INSTALL TRANSMITTER BATTERY

a.
B250772

Install a transmitter battery (lithium battery: CR2016) with the positive (+) side facing upward, as shown in the illustration.

NOTICE:
·

Be careful not to bend the transmitter battery electrode during insertion.

·

Keep the transmitter cover interior free of dust and oil.

·

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.




b.
B283995

Install the cover.


Hide 89071B 5.INSTALL DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY

a.
B213774

Install the door control transmitter module set sub-assembly into the transmitter housing case.


Hide 89751A 6.INSTALL TRANSMITTER HOUSING COVER

a.
B213770

Install the transmitter housing cover to the transmitter housing case.


b.

Check that the transmitter LED illuminates when the switch is pressed.

OK:

Transmitter LED illuminates when switch is pressed.