Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
69780B
1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
69740D
2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
69060A
3.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY
When reusing the removed rear door lock with motor assembly, replace the door lock wiring harness seal on the connector with a new one.
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door with motor lock assembly.
Apply MP grease to the sliding parts of the rear door lock with motor assembly.
When reusing the rear door with motor lock assembly:
Install a new door lock wiring harness seal to the rear door lock with motor assembly.
| *1 | Release Plate |
Insert the rear door lock with motor assembly to the rear door outside handle release plate, and set it to the rear door panel.
Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock with motor assembly.
Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.
68104
4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
68124B
5.INSTALL REAR DOOR QUARTER WINDOW GLASS
Install the rear door quarter window glass in the direction indicated by the arrow in the illustration.
67408F
6.INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY
68152C
7.INSTALL REAR DOOR GLASS RUN
67872
8.INSTALL REAR DOOR WEATHERSTRIP
67842E
9.INSTALL REAR DOOR SERVICE HOLE COVER
68174A
10.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
67604
11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
74260
12.INSTALL REAR ARMREST ASSEMBLY
13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
69284D
14.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
16.INITIALIZE POWER WINDOW CONTROL SYSTEM
17.CHECK POWER WINDOW CONTROL SYSTEM