DESCRIPTION
Smart entry and start system (for start function) data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.
CHECK DLC3
Check the DLC3 (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION).
INSPECT BATTERY VOLTAGE
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery.