This circuit is used to read the DTCs that are output from the transponder key ECU assembly with the intelligent tester.
Disconnect the DLC3 connector.
Disconnect the transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I19-9 (D) - I39-7 (SIL) | Always | Below 1 Ω |
| I39-4 (CG) - Body ground | Always | Below 1 Ω |
| I19-9 (D) - Body ground | Always | 10 kΩ or higher |
| I39-7 (SIL)- Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG