This DTC is stored if the transponder key ECU assembly does not detect that the unlock warning switch assembly is ON even when the key is in the ignition key cylinder. Under normal conditions, the unlock warning switch assembly is ON when the key is in the ignition key cylinder.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2780 | Push Switch / Key Unlock Warning Switch Malfunction | "Unlock warning switch ON" is not detected when the key is in the ignition key cylinder. | ·
Wire harness or connector ·
Unlock warning switch assembly ·
Transponder key ECU assembly |
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Immobiliser / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Key SW | Unlock warning switch signal | ON or OFF | ON: Key in ignition key cylinder
OFF: No key in ignition key cylinder |
- |
| Tester Display |
|---|
| Key SW |
On the intelligent tester screen, the item changes between ON and OFF according to the chart above.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Unlock Warning Switch Assembly) |
| *b | Free |
| *c | Pushed |
Remove the unlock warning switch assembly.
Click hereVehicle Interior>DOOR LOCK>UNLOCK WARNING SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pushed
(Key set) |
Below 1 Ω |
| 1 - 2 | Free
(Key removed) |
10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I19-3 (KSW) - I33-1 (UN+) | Always | Below 1 Ω |
| I19-3 (KSW) - Body ground | Always | 10 kΩ or higher |
| I33-2 (UN-) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG