Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) › 2011.10–2015.04
RM19V0EQ _58 Vehicle Interior _014606 THEFT DETERRENT / KEYLESS ENTRY _0074131 ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) D

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)  SYSTEM DESCRIPTION  


ENGINE IMMOBILISER SYSTEM DESCRIPTION


The engine immobiliser system is designed to prevent the vehicle from being stolen. This system uses the transponder key ECU assembly that stores the key codes of authorized ignition keys. If an attempt is made to start the engine using an unauthorized key, the transponder key ECU assembly sends a signal to the ECM to prohibit fuel delivery and ignition, effectively disabling the engine.


FUNCTION OF MAIN COMPONENTS


Component Outline
Transponder key ECU assembly Checks the key ID code received from the transponder key amplifier and if the results match, an engine start permission signal is sent to the ECM.
Transponder key amplifier When a key is inserted into the ignition key cylinder, the transponder key amplifier receives the key ID code. Then the transponder key amplifier amplifies the key ID code and outputs it to the transponder key ECU assembly.
ECM The ECM receives key ID verification results from the transponder key ECU assembly. The ECM also verifies the ECUs. Then judgment of whether to immobilise the engine is made.
Unlock warning switch assembly The unlock warning switch assembly detects if the key is in the ignition key cylinder and outputs the result to the transponder key ECU assembly.
Front door courtesy light switch assembly (for driver door)*1 The front door courtesy light switch assembly (for driver door) is located on the driver door. This detects door status (open or closed) and outputs data to the transponder key ECU Assembly. This turns on when the driver door is open and turns off when the door is closed.
Security indicator light Depending on the operation of the transponder key ECU assembly, the security indicator light comes on or starts blinking.

*1: for LHD



SYSTEM FUNCTION


a.

When the transponder key ECU assembly detects that the unlock warning switch assembly is on, the transponder key ECU assembly provides current to the transponder key coil built-in transponder key amplifier and produces radio waves. A transponder chip in the key grip receives the radio waves. Upon receiving the radio waves, the transponder chip outputs a key ID code signal. The transponder key coil receives this signal, which is amplified by the transponder key amplifier, and the signal is transmitted to the transponder key ECU assembly.

The transponder key ECU assembly matches the key ID code with the vehicle ID code, which was previously registered in the transponder key ECU assembly, and communicates the results to the ECM.

After the identification results show that the key ID code matches the vehicle's ID code and the transponder key ECU assembly has confirmed their match: 1) the engine immobiliser system does not immobilise the engine and the engine starting controls (fuel injection control and ignition control) enter standby mode; and 2) the transponder key ECU assembly transmits a security indicator light signal that communicates "security indicator light off" to the heater control switch board*1 or air conditioning control assembly*2. Then, the heater control switch board*1 or air conditioning control assembly*2 turns off the security indicator light.

*1: w/ Automatic Air Conditioning System

*2: w/ Manual Air Conditioning System



b.

The security indicator light blinking pattern is as shown below (when changing from the immobiliser set status to the unset status):

B118503E10
0.082,0.065 1.564,0.206 1.483,0.141 10 Security Indicator Light: 0.061,1.354 1.342,1.83 1.281,0.476 10 Normal (Immobiliser system is operating normally) 1.574,1.361 1.839,1.532 0.266,0.17 10 ON 1.56,1.684 1.876,1.84 0.316,0.156 10 OFF 2.19,1.95 3.611,2.094 1.42,0.145 10 Immobiliser Set Status 4.285,1.95 5.855,2.099 1.57,0.149 10 Immobiliser Unset Status 3.192,2.272 5.018,2.412 1.826,0.14 10 Registration Key Recognition 3.961,0.5 5.744,0.809 1.784,0.309 10 Lights up for 2 sec. (Sub key is in ignition key cylinder) 1.687,0.64 2.192,0.779 0.505,0.139 10 0.2 sec. 3.073,0.616 3.579,0.759 0.506,0.143 10 0.2 sec. 3.035,0.926 3.544,1.068 0.509,0.142 10 1.8 sec. 2.69,0.296 3.199,0.441 0.509,0.144 10 1.8 sec. 2.556,1.289 2.646,0.37 2.646,0.37 2.679,0.37 false