CHECK FOR TRANSPONDER KEY ECU ASSEMBLY DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Immobiliser / DTC.
Check the details of the DTC(s) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)>DIAGNOSTIC TROUBLE CODE CHART).
CHECK FOR ECM DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check the details of the DTC(s) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)>DIAGNOSTIC TROUBLE CODE CHART for engine immobiliser system, Engine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM>DIAGNOSTIC TROUBLE CODE CHART for SFI system).
CLEAR TRANSPONDER KEY ECU ASSEMBLY DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Immobiliser / DTC.
Clear the DTC(s).
CLEAR ECM DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Clear the DTC(s).