Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
RM19V0EQ _58 Vehicle Interior _014607 LIGHTING (INT) _0074132 LIGHTING SYSTEM U

LIGHTING (INT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Data List.


e.

Read the Data List according to the display on the intelligent tester.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ACC SW Ignition switch ACC signal/ON or OFF ON or OFF ON: Ignition switch ACC
OFF: Ignition switch off
-
IG SW Ignition switch ON signal/ON or OFF ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
-
RR Door Courtesy SW Rear door courtesy light switch RH signal/ON or OFF ON or OFF ON: Rear door RH open
OFF: Rear door RH closed
-
RL Door Courtesy SW Rear door courtesy light switch LH signal ON or OFF ON: Rear door LH open
OFF: Rear door LH closed
-
FR Door Lock Pos Front door RH unlock detection switch signal LOCK or UNLOCK LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FR Door Courtesy Front door courtesy light switch RH signal ON or OFF ON: Front door RH open
OFF: Front door RH closed
-
FL Door Lock Pos Front door LH unlock detection switch signal LOCK or UNLOCK LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
FL Door Courtesy Front door courtesy light switch LH signal ON or OFF ON: Front door LH open
OFF: Front door LH closed
-
RR-Door Lock Pos SW Rear door RH unlock detection switch signal ON or OFF ON: Rear door LH locked and rear door RH unlocked
ON: Rear door LH unlocked and rear door RH locked
ON: Rear door LH and rear door RH unlocked
OFF: Rear door LH and rear door RH locked
-
RL-Door Lock Pos SW Rear door LH unlock detection switch ON or OFF ON: Rear door LH locked and rear door RH unlocked
ON: Rear door LH unlocked and rear door RH locked
ON: Rear door LH and rear door RH unlocked
OFF: Rear door LH and rear door RH locked
-
Luggage Courtesy SW Luggage compartment door courtesy switch signal OFF or ON ON: Luggage compartment door open
OFF: Luggage compartment door closed
-
Interior Light Control Operation of the illuminated entry system OFF or ON OFF: System not operated
ON: System operated
Customized value is displayed
I/L ON W/Door Key Unlock Function that lights up the interior lights when the doors are unlocked OFF or ON OFF: Function disabled
ON: Function enabled
Customized value is displayed
Lighting Time Lighting time of the delay control function (illuminated entry system) 15s, 7.5s or 30s 15s: 15 seconds
7.5s: 7.5 seconds
30s: 30 seconds
Customized value is displayed
Room Light when Aprchd Function that lights up the interior lights when a key enters any actuation area OFF or ON OFF: Function disabled
ON: Function enabled
Customized value is displayed
I/L when ACC OFF Function that lights up the interior lights when the ignition switch is turned from ON or ACC to off OFF or ON OFF: Function disabled
ON: Function enabled
Customized value is displayed


ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / (desired system) / Active Test.


e.

Perform the Active Test according to the display on the intelligent tester.

Body Electrical > Main Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Illuminated Entry System Personal light*2 ,rear interior light and engine switch illumination*3 ON/OFF
·

No. 1 room light assembly switch in DOOR position*1

·

Interior light door switch is on*2


Relay for Interior Light Auto Cut Function Light cut relay ON/OFF -
Body Electrical > Entry&Start > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Power/Engine SW Light Engine switch light*3 ON/OFF When performing this Active Test, make sure the following condition is met:
The engine switch illumination is off (15 seconds or more have elapsed since it turned from on to off) and the engine switch is on (ACC) or on (IG), or the engine is running.

*1: w/o Sliding Roof

*2: w/ Sliding Roof

*3: w/ Smart Entry and Start System