Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT SWITCH
RM19V0EQ _58 Vehicle Interior _014607 LIGHTING (INT) _0074138 VANITY LIGHT SWITCH G

LIGHTING (INT)  VANITY LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 74320 1.INSPECT VISOR ASSEMBLY LH

a.

Inspect the vanity light switch.

i.
E224621
1.125,2.948 1.208,2.198 1.208,2.198 1.427,2.198 false 2,2.563 2.063,2 2.063,2 2.167,2 false 1.802,3.76 1.885,4.146 1.885,4.146 2.031,4.146 false 0.115,0.042 0.302,0.229 0.188,0.188 10 false *a 1.458,2.115 1.646,2.302 0.188,0.188 10 false *1 2.188,1.906 2.375,2.094 0.188,0.188 10 false *b 2.031,4.052 2.219,4.24 0.188,0.188 10 false *c
*1 Mirror Cover
*a Component without harness connected
(Visor Assembly LH)
*b Visor up
*c Visor down


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Visor up 10 kΩ or higher
1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
1 - 2 Mirror cover fully open with visor down Below 1 Ω


If the result is not as specified, replace the visor assembly LH.



Hide 74310 2.INSPECT VISOR ASSEMBLY RH

a.

Inspect the vanity light switch.

i.
E224622
2.281,3 2.198,2.25 2.198,2.25 1.979,2.25 false 0.948,2.344 0.875,1.781 0.875,1.781 0.781,1.781 false 1.604,3.729 1.521,4.104 1.521,4.104 1.385,4.104 false 0.146,0.083 0.333,0.271 0.188,0.188 10 false *a 1.792,2.156 1.979,2.344 0.188,0.188 10 false *1 0.583,1.677 0.771,1.865 0.188,0.188 10 false *b 1.188,4.01 1.375,4.198 0.188,0.188 10 false *c
*1 Mirror Cover
*a Component without harness connected
(Visor Assembly RH)
*b Visor up
*c Visor down


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Visor up 10 kΩ or higher
1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
1 - 2 Mirror cover fully open with visor down Below 1 Ω


If the result is not as specified, replace the visor assembly RH.