87810
1.REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/o EC Mirror)
for Type A:
Disengage the 2 claws and disconnect the inner mirror base cover.
| *1 | Lock Lever |
Pull the lock lever in the direction indicated by the arrow in the illustration, and slide the inner rear view mirror assembly upward to remove it.
for Type B:
Using a T20 "TORX" socket wrench, remove the screw.
Slide the inner rear view mirror assembly in the direction indicated by the arrow shown in the illustration to remove it.
87834
2.REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER (w/ EC Mirror)
w/o Automatic High Beam System:
Disengage the 2 claws and slide the inner rear view mirror stay holder cover as shown in the illustration.
Disengage the 6 claws and remove the inner rear view mirror stay holder cover.
w/ Automatic High Beam System:
Disengage the 2 claws and slide the inner rear view mirror stay holder cover as shown in the illustration.
Disengage the 2 claws and remove the inner rear view mirror stay holder cover.
87810
3.REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/ EC Mirror)
w/o Automatic High Beam System:
Disconnect the connector.
Using a T20 "TORX" socket wrench, remove the screw and inner rear view mirror assembly.
w/ Automatic High Beam System:
Do not touch of the camera lens (built into the inner rear view mirror assembly) with a bare hand.
Do not allow anything to adhere to the camera lens (built into the inner rear view mirror assembly).
Do not apply strong impact to the inner rear view mirror assembly.
Do not allow any liquids to get on the inner rear view mirror assembly.
Disconnect the connector.
Using a T20 "TORX" socket wrench, remove the screw and inner rear view mirror assembly.