Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Manual Seat)
RM19V0EQ _58 Vehicle Interior _014611 SEAT _0074161 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Be sure to read precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ VSC)>PRECAUTION

·

If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.



NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 71910A 3.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72138J 4.REMOVE REAR OUTER SEAT TRACK BRACKET COVER

a.

Lift up the seat track adjusting handle and move the seat to the foremost position.


b.
B280204

Disengage the 2 claws to remove the rear outer seat track bracket cover.


Hide 72158 5.REMOVE REAR INNER SEAT TRACK BRACKET COVER

a.
B297959

Disengage the 2 claws to remove the rear inner seat track bracket cover.


Hide 6.REMOVE FRONT SEAT ASSEMBLY

a.
B280114

Remove the 2 bolts on the rear side of the seat.


b.

Lift up the seat track adjusting handle and move the seat to the rearmost position.


c.

Remove the 2 bolts on the front side of the seat.


d.

Disconnect each connector and clamp under the seat.


e.

Lift up the seat track adjusting handle and move the seat to the center position. Then, operate the reclining adjuster release handle and move the seatback to the upright position.


f.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.