84922A
1.INSPECT LUMBAR FRONT POWER SEAT SWITCH
| *1 | ·
Hold Switch (for LHD) ·
Release Switch (for RHD) |
| *2 | ·
Release Switch (for LHD) ·
Hold Switch (for RHD) |
| *a | Component without harness connected
(Lumbar Front Power Seat Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Hold | Below 1 Ω |
| 1 - 2 | ||
| 3 - 2 | Off | |
| 1 - 2 | ||
| 3 - 2 | Release | |
| 1 - 5 |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 5 | Hold | Below 1 Ω |
| 3 - 2 | ||
| 1 - 2 | Off | |
| 3 - 2 | ||
| 1 - 2 | Release | |
| 3 - 5 |
If the result is not as specified, replace the lumbar front power seat switch.