1.INSPECT AIR CONDITIONING PRESSURE SENSOR
Check the wire harness.
Disconnect the A55 air conditioning pressure sensor connector.
Disconnect the I77 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A55-1 (-) - I77-13 (SG-2) | Always | Below 1 Ω |
| A55-2 (PR) - I77-9 (PRE) | Always | Below 1 Ω |
| A55-3 (+) - I77-10 (S5-3) | Always | Below 1 Ω |
| A55-1 (-) - Body ground | Always | 10 kΩ or higher |
| A55-2 (PR) - Body ground | Always | 10 kΩ or higher |
| A55-3 (+) - Body ground | Always | 10 kΩ or higher |
If the resistance is not as specified, repair the wire harness.
Reconnect the I77 air conditioning amplifier assembly connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch condition | Specified Condition |
|---|---|---|
| A55-3 (+) - Body ground | Ignition switch ON | 4.75 to 5.25 V |
If the voltage is not as specified, repair the wire harness or replace air conditioning amplifier assembly.
Check the air conditioning pressure sensor.
Install a manifold gauge set.
Connect the connector to the air conditioning pressure sensor.
Warm up the engine.
Turn the A/C switch on.
| *a | Component with harness connected
(Air Conditioning Amplifier) |
Measure the voltage according to the value(s) in the table below.
Check from the rear of the connector while it is connected to the air conditioning amplifier.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I77-9 (PRE) - I77-13 (SG-2) | Refrigerant pressure:
(less than 3025 kPa (30.9 kgf/cm2, 439 psi) and more than 176 kPa (1.8 kgf/cm2, 25 psi)) |
0.50 to 4.80 V |
If the voltage is not as specified, replace the air conditioning pressure sensor.