Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM19V0EQ _58 Vehicle Interior _014613 HEATING / AIR CONDITIONING _0074197 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

The main power source is supplied to the air conditioning amplifier assembly when the ignition switch is ON.

The power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E229257
5.938,2.125 6.396,2.302 0.458,0.177 10 false GND 5.729,0.76 5.833,0.938 0.104,0.177 10 false 1 5.656,2.042 5.833,2.219 0.177,0.177 10 false 14 5.469,3.469 5.792,3.646 0.323,0.177 10 false I77 5.469,3.646 7.063,3.979 1.594,0.333 10 false Air Conditioning Amplifier Assembly 0.208,1.5 1.604,1.844 1.396,0.344 10 false from Ignition Switch*1 or Certification ECU*2 0.854,3.792 3.615,4.031 2.76,0.24 10 false *1: w/o Smart Entry and Start System 0.854,4.083 3.135,4.323 2.281,0.24 10 false *2: w/ Smart Entry and Start System 5.938,0.854 6.385,1.031 0.448,0.177 10 false IG+ 4.521,1.188 5.208,1.365 0.688,0.177 10 false A/C-IG1 3.042,1.906 3.802,2.083 0.76,0.177 10 false IG1 NO. 1 0.813,0.854 1.583,1.031 0.771,0.177 10 false from Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BATTERY)
a.

Disconnect the I77 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
I77-1 (IG+) - Body ground Ignition switch off Below 1 V
I77-1 (IG+) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I77-14 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR