58903A
1.REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY
Disengage the 4 claws and 4 clips to remove the console rear end panel sub-assembly.
2.REMOVE CONSOLE COMPARTMENT DOOR LOCK SUB-ASSEMBLY (for Manual Transaxle)
Remove the 2 screws.
Using a screwdriver, disengage the 6 claws.
Tape the screwdriver tip before use.
Disengage the 2 guides to remove the console compartment door lock sub-assembly as shown in the illustration.
3.REMOVE CONSOLE COMPARTMENT DOOR LOCK SUB-ASSEMBLY (for Automatic Transaxle)
Remove the 2 screws.
Using a screwdriver, disengage the 8 claws.
Tape the screwdriver tip before use.
Disengage the 2 guides to remove the console compartment door lock sub-assembly as shown in the illustration.
58959B
4.REMOVE CONSOLE COMPARTMENT DOOR CUSHION (for Manual Transaxle)
Remove the 2 console compartment door cushions from the console compartment door lock sub-assembly.
58959B
5.REMOVE CONSOLE COMPARTMENT DOOR CUSHION (for Automatic Transaxle)
Remove the 4 console compartment door cushions from the console compartment door lock sub-assembly.
6.REMOVE CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY (for Automatic Transaxle)
| *a | Stopper |
Disengage the 2 stoppers and push the console compartment door sub-assembly as shown in the illustration.
Using a moulding remover, disengage the stopper and push the console compartment door sub-assembly as shown in the illustration to disengage the 2 guides and remove the console compartment door sub-assembly.
| *a | Stopper | *b | Moulding remover |
58871
7.REMOVE CONSOLE BOX CUSHION (for Automatic Transaxle)
Disengage the 2 claws to remove the console box cushion.
Use the same procedure for the other console box cushions.