Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM19V0EQ _59 Vehicle Exterior _014616 WINDOW / GLASS _0074215 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Rear Power Window RH does not Operate with Rear Power Window Switch RH  


DESCRIPTION

When the ignition switch is ON, the power window regulator motor assembly (for rear RH door) is operated by the power window regulator switch assembly (for rear RH door).

WIRING DIAGRAM

B246035
4.354,3.031 5.906,3.438 1.552,0.406 10 false Power Window Regulator Master Switch Assembly 2.344,2.771 3.896,3.292 1.552,0.521 10 false Power Window Regulator Switch Assembly (for Rear RH Door) 0.313,2.771 1.875,3.292 1.563,0.521 10 false Power Window Regulator Motor Assembly (for Rear RH Door) 4.354,2.896 5.375,3.229 1.021,0.333 10 false K10*1, J10*2 2.344,2.615 2.719,2.938 0.375,0.323 10 false L6 0.313,2.615 0.781,3.01 0.469,0.396 10 false L5 6.188,2.25 6.396,2.49 0.208,0.24 10 false E 6.365,2.25 7.063,2.646 0.698,0.396 10 false 1*1, 9*2 6.271,3.115 7.156,3.417 0.885,0.302 10 false *1: for LHD 6.271,3.354 7.146,3.635 0.875,0.281 10 false *2: for RHD 5.219,1.625 5.51,1.948 0.292,0.323 10 false B 5.396,1.427 6.083,1.969 0.688,0.542 10 false 6 4.385,2.052 4.75,2.458 0.365,0.406 10 false U 2.729,1.958 3.01,2.313 0.281,0.354 10 false U 2.552,1.958 2.844,2.354 0.292,0.396 10 false 4 1.354,1.958 1.625,2.24 0.271,0.281 10 false U 1.521,1.948 1.802,2.281 0.281,0.333 10 false 1 3.219,2.052 3.594,2.396 0.375,0.344 10 false SU 3.167,1.906 3.406,2.177 0.24,0.271 10 false B 3.219,2.427 3.51,2.646 0.292,0.219 10 false SD 4.385,2.427 4.74,2.729 0.354,0.302 10 false D 2.729,2.333 3.031,2.604 0.302,0.271 10 false D 2.552,2.333 2.813,2.594 0.26,0.26 10 false 1 1.354,2.333 1.708,2.635 0.354,0.302 10 false D 1.521,2.333 1.854,2.604 0.333,0.271 10 false 2 3.177,1.729 3.417,1.938 0.24,0.208 10 false 3 3.5,2.052 3.823,2.448 0.323,0.396 10 false 5 3.677,2.052 4.531,2.396 0.854,0.344 10 false 10*1, 16*2 3.677,2.438 4.583,2.802 0.906,0.365 10 false 18*1, 15*2 3.5,2.448 3.781,2.75 0.281,0.302 10 false 2 3.74,0.896 4.875,1.292 1.135,0.396 10 false DOOR NO. 1 2.01,1.417 3.073,1.76 1.063,0.344 10 false DOOR R/R 0.292,0.708 1.625,1.104 1.333,0.396 10 false from DOOR Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR RH DOOR) - BATTERY)
a.

Disconnect the power window regulator switch assembly (for rear RH door) connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L6-3 (B) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR RH DOOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR RH DOOR)
a.
B164433
2.177,2.188 2.385,2.74 false 1.938,2.188 2.063,2.74 false 1.521,2.188 1.427,2.74 false 1.292,2.188 1.094,2.74 false 1.729,2.177 1.729,2.729 false 0.198,0.219 0.385,0.365 0.188,0.146 10 *a 1.385,2.75 1.521,2.896 0.135,0.146 10 U 0.969,2.75 1.281,3.01 0.313,0.26 10 SU 2.385,2.75 2.521,2.896 0.135,0.146 10 D 1.698,2.75 1.833,2.896 0.135,0.146 10 B 1.979,2.75 2.198,2.896 0.219,0.146 10 SD
*a Component without harness connected
(Power Window Regulator Switch Assembly (for Rear RH Door))


Remove the power window regulator switch assembly (for rear RH door).

Click hereVehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>REMOVAL


b.

Measure the resistance when the switch is operated according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (D) - 2 (SD) UP Below 1 Ω
3 (B) - 4 (U) Below 1 Ω
1 (D) - 2 (SD) off Below 1 Ω
4 (U) - 5 (SU) Below 1 Ω
4 (U) - 5 (SU) DOWN Below 1 Ω
1 (D) - 3 (B) Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH (FOR REAR RH DOOR) - POWER WINDOW REGULATOR MOTOR)

NG

REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR RH DOOR)

3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH (FOR REAR RH DOOR) - POWER WINDOW REGULATOR MOTOR)
a.

Disconnect the power window regulator motor assembly (for rear RH door) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L6-4 (U) - L5-1 (U) Always Below 1 Ω
L6-1 (D) - L5-2 (D) Always Below 1 Ω
L6-4 (U) - Body ground Always 10 kΩ or higher
L6-1 (D) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
a.
B164359
2.313,2.01 2.563,2.635 false 2.375,1.708 3,2.635 false 1.615,2.01 1.938,2.635 false 1.594,1.75 1.49,2.635 false 1.083,2.01 0.875,2.635 false 1.396,1.979 1.229,2.635 false 1.063,1.792 0.438,2.646 false 0.198,0.083 0.719,0.542 0.521,0.458 10 false *a 2.469,2.646 2.844,2.906 0.375,0.26 10 false U*A 2.875,2.635 3.26,2.948 0.385,0.313 10 false E*A 1.854,2.635 2.281,2.906 0.427,0.271 10 false D*B 0.667,2.635 1.052,2.927 0.385,0.292 10 false D*A 1.052,2.635 1.365,2.865 0.313,0.229 10 false U*B 0.281,2.667 0.708,3 0.427,0.333 10 false E*B 1.438,2.635 1.573,2.823 0.135,0.188 10 false B
*A for LHD
*B for RHD
*a Component without harness connected
(Power Window Regulator Master Switch Assembly)


Remove the power window regulator master switch assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL


b.

Measure the resistance when the switch is operated according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
6 (B) - 10 (U) UP Below 1 Ω
1 (E) - 18 (D) Below 1 Ω
1 (E) - 10 (U) off Below 1 Ω
1 (E) - 18 (D) Below 1 Ω
6 (B) - 10 (U) DOWN Below 1 Ω
1 (E) - 18 (D) Below 1 Ω

for RHD
Tester Connection Condition Specified Condition
6 (B) - 16 (U) UP Below 1 Ω
9 (E) - 15 (D) Below 1 Ω
9 (E) - 16 (U) off Below 1 Ω
9 (E) - 15 (D) Below 1 Ω
6 (B) - 16 (U) DOWN Below 1 Ω
9 (E) - 15 (D) Below 1 Ω



Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH - POWER WINDOW REGULATOR SWITCH (FOR REAR RH DOOR))

NG

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH - POWER WINDOW REGULATOR SWITCH (FOR REAR RH DOOR))
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
K10-10 (U) - L6-5 (SU) Always Below 1 Ω
K10-18 (D) - L6-2 (SD) Always Below 1 Ω
K10-10 (U) - Body ground Always 10 kΩ or higher
K10-18 (D) - Body ground Always 10 kΩ or higher

for RHD
Tester Connection Condition Specified Condition
J10-16 (U) - L6-5 (SU) Always Below 1 Ω
J10-15 (D) - L6-2 (SD) Always Below 1 Ω
J10-16 (U) - Body ground Always 10 kΩ or higher
J10-15 (D) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR RH DOOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR