The power window regulator motor assembly (for driver door) is operated by the power window regulator master switch assembly. The power window regulator motor assembly (for driver door) has motor, regulator and ECU functions.
When the ECU determines that the power window regulator motor assembly (for driver door) has not been initialized, DTC B2313 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2313 | Glass Position Initialization Incomplete | ·
Power window regulator motor assembly not initialized ·
Power window regulator motor assembly malfunctions ·
Battery disconnected when ignition switch ON |
·
Power window regulator motor assembly (for driver door) not initialized ·
Power window regulator motor assembly (for driver door) |
DTC B2313 can be stored in the power window regulator motor assembly (for driver door).
When disconnecting the battery while the ignition switch is ON, DTC B2313 is stored.
If a power window regulator motor assembly (for driver door) has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Initialize the power window regulator motor assembly (for driver door).
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Wait for at least 10 seconds, and then turn the ignition switch to ON.
Check for DTCs.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR
B2313 output does not recur.
| Proceed to |
|---|
| OK |
| NG |
OK
NG