Home › Vehicle Exterior › DOOR / HATCH › HOOD › 2011.10–2015.04
RM19V0EQ _59 Vehicle Exterior _014618 DOOR / HATCH _0074220 HOOD G

DOOR / HATCH  HOOD  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 53301 1.INSPECT HOOD SUB-ASSEMBLY

a.

Check that the clearance measurements of areas a through d are within each standard range.

B291323
0.455,3.599 0.574,3.769 0.119,0.17 10 a 2.475,0.872 2.588,1.027 0.114,0.155 10 b 5.552,0.737 5.66,0.889 0.108,0.152 10 c 5.29,1.424 5.412,1.588 0.122,0.164 10 d

Standard Clearance
Area Measurement Area Measurement
a 2.6 to 6.6 mm (0.102 to 0.260 in.) b 3.7 to 7.7 mm (0.145 to 0.303 in.)
c 2.3 to 5.3 mm (0.0906 to 0.209 in.) d -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)