Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT
RM19V0EQ _59 Vehicle Exterior _014618 DOOR / HATCH _0074221 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 53450A 1.REMOVE HOOD SUPPORT ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.



a.
B277173
1.188,1.104 0.885,0.948 false 0.833,2.708 1.51,3.177 false 1.208,1.052 1.417,1.25 0.208,0.198 10 true *1 1.542,3.094 1.74,3.25 0.198,0.156 10 true *1 1.167,0.813 1.385,1.01 0.219,0.198 10 true (1) 1.167,0.375 1.375,0.573 0.208,0.198 10 false (2) 0.292,2.406 0.5,2.604 0.208,0.198 10 true (1) 0.25,2.646 0.458,2.813 0.208,0.167 10 false (2)
*1 Protective Tape


Using a screwdriver, remove the 2 stop rings as indicated by the arrows, in the order shown in the illustration.

HINT:

Tape the screwdriver tip before use.



b.

Release the ball joint and remove the hood support assembly.

NOTICE:

Remove the hood support assembly while supporting the hood by hand.