Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
87961
1.INSTALL OUTER MIRROR
| *1 | Spring Dampener |
Set the spring dampener as shown in the illustration.
Move the part that the outer mirror attaches to so that it is vertical.
w/o Blind Spot Monitor System:
Engage the 4 claws to install the outer mirror.
w/ Blind Spot Monitor System:
Connect the connectors.
Engage the 4 clamps.
Engage the 4 claws to install the outer mirror.
Do not pinch the wire harness.