Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
87945
1.REMOVE OUTER MIRROR COVER
Push the lower part of the mirror surface and tilt it.
| *1 | Protective Tape |
Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws.
w/o Side Turn Signal Light:
Disengage the 3 claws and remove the outer mirror cover as shown in the illustration.
w/ Side Turn Signal Light:
Disengage the 3 claws and remove the outer mirror cover as shown in the illustration.