Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM19V0EQ _59 Vehicle Exterior _014620 WIPER / WASHER _0074239 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  Wiper ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to the windshield wiper relay assembly.

WIRING DIAGRAM

E196302
4.894,2.549 5.233,2.736 0.339,0.187 10 I72 4.894,2.736 7.056,2.923 2.162,0.187 10 Windshield Wiper Relay Assembly 0.598,0.922 2.016,1.105 1.418,0.183 10 from IG1 NO. 1 Relay 5.453,0.912 5.759,1.112 0.306,0.2 10 IG 5.453,2.15 5.667,2.35 0.214,0.2 10 E 5.203,2.064 5.377,2.215 0.174,0.151 10 12 5.273,0.813 5.398,0.992 0.125,0.179 10 2 3.596,1.057 4.148,1.253 0.553,0.196 10 WIPER 0.598,1.504 2.029,1.686 1.431,0.183 10 from IG1 NO. 2 Relay 3.364,1.68 4.438,1.876 1.074,0.196 10 ECU-IG1 NO. 2 5.467,1.52 5.785,1.72 0.318,0.2 10 WIG 5.203,1.434 5.377,1.585 0.174,0.151 10 16

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - BATTERY AND BODY GROUND)
a.
E144475
1.5,1.042 1.958,1.344 0.458,0.302 2.708,2.188 2.99,2.646 false 1.156,2.427 1.156,2.896 false 0.74,2.802 1,2.198 false 1.646,1.104 2.01,1.271 0.365,0.167 10 false I72 0.323,0.292 0.594,0.438 0.271,0.146 10 false *a 2.979,2.667 3.188,2.833 0.208,0.167 10 false E 1.052,2.917 1.375,3.083 0.323,0.167 10 false WIG 0.615,2.823 0.802,2.99 0.188,0.167 10 false IG
*a Front view of wire harness connector
(to Windshield Wiper Relay Assembly)


Disconnect the I72 windshield wiper relay assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I72-2 (IG) - Body ground Ignition switch ON 11 to 14 V
I72-16 (WIG) - Body ground Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I72-12 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR