Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM19V0EQ _59 Vehicle Exterior _014620 WIPER / WASHER _0074242 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


PROCEDURE

Hide 45287 1.REMOVE LOWER STEERING COLUMN COVER

NOTICE:

Removing the lower steering column cover in the incorrect order will cause the parts to break.


a.

Release the tilt and telescopic lever, and fully extend and lower the steering column assembly.


b.

Lock the tilt and telescopic lever.


c.
E235255

Turn the steering wheel assembly to the left and remove the screw.


d.
E235256

Turn the steering wheel assembly to the right and remove the screw.


e.
E235257

Push the right and left sides of the lower steering column cover to disengage the 2 claws.


f.
E235258

Insert your fingers into the opening of the tilt lever of the lower steering column cover to disengage the 2 claws.

HINT:

Spread the claws to disengage them.



Hide 45286B 2.REMOVE UPPER STEERING COLUMN COVER

a.
E226468

Disengage the 4 clips and 2 guides to separate the instrument cluster finish panel assembly from the upper steering column cover.


b.
E226469

Disengage the 2 claws and remove the upper steering column cover.


Hide 84650 3.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

a.
E226470

Disconnect each connector.


b.

Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

NOTICE:

If the claw is pulled with excessive force, it may break.