Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM19V0EQ _59 Vehicle Exterior _014620 WIPER / WASHER _0074242 WIPER SWITCH G

WIPER / WASHER  WIPER SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FRONT WIPER INTERMITTENT OPERATION (w/o Auto Wiper System)

a.
E171721
0.177,1.146 0.635,1.417 0.458,0.271 2.813,1.146 3.271,1.417 0.458,0.271 1.167,1.083 0.896,0.656 false 2.469,1.458 2.563,1.885 false 0.073,0.031 0.438,0.344 0.365,0.313 10 false *a 0.323,1.177 0.729,1.427 0.406,0.25 10 false I32 0.75,0.479 1.188,0.792 0.438,0.313 10 false +1 2.958,1.177 3.313,1.417 0.354,0.24 10 false I31 2.49,1.896 2.885,2.177 0.396,0.281 10 false EW
*a Component with harness connected
(Windshield Wiper Switch Assembly)


for LHD:

i.

Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).


ii.

Turn the ignition switch to ON.


iii.

Turn the wiper switch to the INT position.


iv.

Operate the intermittent wiper relay and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

OK:

Voltage changes as shown in the illustration.


E136493
2.625,0.104 3.104,0.271 0.479,0.167 10 false FAST: 1.927,0.385 2.615,0.563 0.688,0.177 10 false 11 to 14 V 2.344,0.885 2.594,1.063 0.25,0.177 10 false 0 V 3.177,1.385 3.531,1.563 0.354,0.177 10 false Start 0.073,0.792 1.885,1.146 1.813,0.354 10 false I32-3 (+1) and I31-4 (EW): 0.771,1.375 1.854,1.552 1.083,0.177 10 false Wiper Operation: 3.354,1 4.542,1.198 1.188,0.198 10 false 1.6 +/- 1 seconds 5.792,1 7.021,1.198 1.229,0.198 10 false 10.7 +/- 5 seconds 2.729,1.385 3.083,1.563 0.354,0.177 10 false Stop 5.583,1.385 5.938,1.563 0.354,0.177 10 false Start 4.792,1.385 5.146,1.563 0.354,0.177 10 false Stop 4.438,0.104 4.979,0.302 0.542,0.198 10 false SLOW: 0.073,0.583 1.844,0.979 1.771,0.396 10 false Voltage between terminals

If the result is not as specified, replace the windshield wiper switch assembly.



b.
E226489
0.177,1.115 0.635,1.385 0.458,0.271 2.813,1.115 3.271,1.385 0.458,0.271 0.865,1.844 0.948,1.469 false 2.281,1.083 2.844,0.74 false 0.125,0.052 0.313,0.229 0.188,0.177 10 false *a 0.292,1.167 0.594,1.344 0.302,0.177 10 false I31 2.917,1.156 3.198,1.323 0.281,0.167 10 false I32 2.854,0.615 3.063,0.781 0.208,0.167 10 false +1 0.76,1.854 1.083,2.021 0.323,0.167 10 false EW
*a Component with harness connected
(Windshield Wiper Switch Assembly)


for RHD:

i.

Connect a voltmeter positive (+) lead to terminal I32-2 (+1) and a negative (-) lead to terminal I31-7 (EW).


ii.

Turn the ignition switch to ON.


iii.

Turn the wiper switch to the INT position.


iv.

Operate the intermittent wiper relay and check the voltage between terminals I32-2 (+1) and I31-7 (EW).

OK:

Voltage changes as shown in the illustration.


E136493
2.646,0.094 3.125,0.26 0.479,0.167 10 false FAST: 1.927,0.385 2.615,0.563 0.688,0.177 10 false 11 to 14 V 2.344,0.885 2.594,1.063 0.25,0.177 10 false 0 V 3.156,1.396 3.51,1.573 0.354,0.177 10 false Start 0.115,0.802 1.979,1.146 1.865,0.344 10 false I32-2 (+1) and I31-7 (EW): 0.771,1.375 1.854,1.552 1.083,0.177 10 false Wiper Operation: 3.354,1 4.479,1.198 1.125,0.198 10 false 1.6 +/- 1 seconds 5.792,1 7.021,1.198 1.229,0.198 10 false 10.7 +/- 5 seconds 2.729,1.396 3.083,1.573 0.354,0.177 10 false Stop 5.594,1.396 5.948,1.573 0.354,0.177 10 false Start 4.802,1.396 5.156,1.573 0.354,0.177 10 false Stop 4.438,0.094 4.979,0.292 0.542,0.198 10 false SLOW: 0.115,0.594 1.896,1.031 1.781,0.438 10 false Voltage between terminals

If the result is not as specified, replace the windshield wiper switch assembly.



Hide 2.INSPECT FRONT WASHER OPERATION

a.
E171721
0.177,1.146 0.635,1.417 0.458,0.271 2.813,1.146 3.271,1.417 0.458,0.271 1.167,1.083 0.896,0.656 false 2.448,1.427 2.542,1.854 false 0.073,0.031 0.479,0.375 0.406,0.344 10 *a 0.323,1.177 0.719,1.396 0.396,0.219 10 I32 0.75,0.479 1.146,0.813 0.396,0.333 10 +1 2.958,1.177 3.344,1.427 0.385,0.25 10 I31 2.469,1.865 2.927,2.135 0.458,0.271 10 EW
*a Component with harness connected
(Windshield Wiper Switch Assembly)


for LHD:

i.

Connect a voltmeter positive (+) lead to terminal I32-3 (+1) and a negative (-) lead to terminal I31-4 (EW).


ii.

Turn the ignition switch to ON.


iii.

Turn the washer switch on and off, and check the voltage between terminals I32-3 (+1) and I31-4 (EW).

OK:

Voltage changes as shown in the illustration.


E226602
4.115,1.333 4.042,1.5 false 4.719,1.333 4.802,1.51 false 0.969,1.01 2.75,1.344 1.781,0.333 10 false I32-3 (+1) and I31-4 (EW): 1.635,0.26 2.625,0.594 0.99,0.333 10 false Washer Switch: 2.51,1.49 4.448,1.719 1.938,0.229 10 false Approximately 0.5 seconds 4.604,1.479 6.448,1.74 1.844,0.26 10 false Approximately 2.2 seconds 2.938,0.823 3.594,1.135 0.656,0.313 10 false 11 to 14 V 3.365,1.146 3.74,1.49 0.375,0.344 10 false 0 V 3.292,0.469 3.604,0.781 0.313,0.313 10 false OFF 3.344,0.198 3.583,0.51 0.24,0.313 10 false ON 0.969,0.823 2.75,1.156 1.781,0.333 10 false Voltage between terminals

If the result is not as specified, replace the windshield wiper switch assembly.



b.
E226489
0.177,1.115 0.635,1.385 0.458,0.271 2.813,1.115 3.271,1.385 0.458,0.271 0.865,1.844 0.948,1.469 false 2.281,1.083 2.844,0.74 false 0.125,0.052 0.313,0.229 0.188,0.177 10 false *a 0.292,1.167 0.594,1.344 0.302,0.177 10 false I31 2.917,1.156 3.198,1.323 0.281,0.167 10 false I32 2.854,0.615 3.063,0.781 0.208,0.167 10 false +1 0.76,1.854 1.083,2.021 0.323,0.167 10 false EW
*a Component with harness connected
(Windshield Wiper Switch Assembly)


for RHD:

i.

Connect a voltmeter positive (+) lead to terminal I32-2 (+1) and a negative (-) lead to terminal I31-7 (EW).


ii.

Turn the ignition switch to ON.


iii.

Turn the washer switch on and off, and check the voltage between terminals I32-2 (+1) and I31-7 (EW).

OK:

Voltage changes as shown in the illustration.


E226602
4.104,1.323 4.031,1.49 false 4.708,1.323 4.792,1.5 false 0.979,0.813 2.76,1.146 1.781,0.333 10 false Voltage between terminals 1.604,0.271 2.594,0.604 0.99,0.333 10 false Washer Switch: 2.458,1.49 4.313,1.688 1.854,0.198 10 false Approximately 0.5 seconds 4.594,1.49 6.552,1.708 1.958,0.219 10 false Approximately 2.2 seconds 2.927,0.875 3.583,1.188 0.656,0.313 10 false 11 to 14 V 3.365,1.156 3.708,1.469 0.344,0.313 10 false 0 V 3.281,0.469 3.594,0.781 0.313,0.313 10 false OFF 3.333,0.188 3.573,0.5 0.24,0.313 10 false ON 0.979,0.99 2.76,1.323 1.781,0.333 10 false I32-2 (+1) and I31-7 (EW):

If the result is not as specified, replace the windshield wiper switch assembly.